Utilization of various non-woven waste forms as reinforcement in polymeric composites

Ipek Yalcin, Telem Gok Sadikoglu, Omer Berk Berkalp*, Mustafa Bakkal

*Bu çalışma için yazışmadan sorumlu yazar

Araştırma sonucu: ???type-name???Makalebilirkişi

31 Atıf (Scopus)

Özet

In this study, various forms of non-woven waste were recycled for the manufacture of composites by the extrusion technique. The performance of the composites, as well as the effect of the reprocessing steps, was investigated with regards to the mechanical and thermal properties. A reinforcement material of polyester non-woven waste in differing forms (cut piece, fiber and particle) and a matrix of polypropylene (PP) and low-density polyethylene (LDPE) were used. Performance tests were evaluated based on the type of reinforcement material. Particle form reinforced composites were subjected to reprocessing and tested for their performance. Results indicate that particle type reinforcement maintained better mechanical performance, whereas reinforcements using cut pieces and fibers showed enhanced thermal insulation with lower densities. The effect of the reprocessing of the particle forms has been observed positively on the tensile characteristics, especially up to the second stage.

Orijinal dilİngilizce
Sayfa (başlangıç-bitiş)1551-1562
Sayfa sayısı12
DergiTextile Reseach Journal
Hacim83
Basın numarası15
DOI'lar
Yayın durumuYayınlandı - Eyl 2013

Finansman

This work was supported by TUBITAK (The Scientific and Technological Research Council of Turkey) (Project Number 107M354) and Istanbul Technical University, The Young Researchers Support Program (Project Number 33249).

FinansörlerFinansör numarası
TUBITAK
Türkiye Bilimsel ve Teknolojik Araştirma Kurumu107M354
Istanbul Teknik Üniversitesi33249

    Parmak izi

    Utilization of various non-woven waste forms as reinforcement in polymeric composites' araştırma başlıklarına git. Birlikte benzersiz bir parmak izi oluştururlar.

    Alıntı Yap